Order online or over the phone

call us at 1-888-520-6689 weekdays

8:30am - 5:00pm central time zone

TOLL FREE1-888-520-6689

Andis Outliner II TRIMMER - # 04603

$ 56.99

Andis Outliner II TRIMMER - # 04603

$ 56.99


Andis Outliner II TRIMMER - # 04603

Close Cutting trimmer Perfect for Outlining & Fading.

Fine cutting teeth ideal for trimming necks, beards, mustaches and edging around ears. Powerful magnetic motor runs cool and quiet. Contoured housing with high-speed motor heavy-duty 8-foot cord with hanger loop.

. Perfect for all-around outlining and fading

. Equipped with extremely close-cutting blade

. High-quality carbon-steel blades specially hardened for long cutting life.

. Excellent for dry shaving

. Contoured housing with high-speed motor

Congratulations! You just went first class when you bought this Andis product. Careful workmanship and quality design have been the hallmarks of Andis products since 1922.

IMPORTANT SAFEGUARDS: When using an electrical appliance, basic precautions should always be followed, including the following

Keywords: andis outliner ii trimmer

Please read the following instructions before using your new Andis Trimmer. Give it the care that a fine precisoin built instrument deserves and it will give you years to service. Before starting trimmer remove blade guard. Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start trimmer move switch button to on position, to stop, move switch button back to original position. After using your Andis Trimmer, rewrap cord and store in a safe place. Some of the "basic" uses for a trimmer are illustarted below.

USER MAINTENANCE: The internal mechanism of your trimmer has been permanently lubricated at the factor. Other than the recommended maintenance described in this manual, no other maintenance should be performed, except by Andis Company of an Andis Authorized Repair Service station.

POWER ADJUSTMENT FOR MODEL SLII AND SL3: Your andis trimmer has been adjusted to line voltage at the factory. However because of voltage variations it may be necessary to adjust the power setting for your area. If the power adjustment is off, you will usually notive a "clatter" when the trimmer is "on" or introduced into the hair.

TO ADJUST YOUR TRIMMER:

1. Oil the blades

2. The power screw is located in the lower part of the housing opposite the switch.

3. Turn your trimmer "on"

4. Using a standard screw driver that fits the slot, turn the powescrew counter clock-wise until the trimmer clatters continuously. Then turn the screw clockwise carefully until the clatter ceases.

5. Your trimmer is now adjusted to its optimum power setting.

CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES: Blades should be oiled before, during and after each use. If your tirmmer baldes leave streak or slows down, its a sure sign blades need oil. The trimmer should be held in a position shown to prevent oil from getting into motor. Place a few drops of Andis Trimmer Oil on teh front and side of the cutter blades. Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are an excellent trimmer coolant. Always repalce broken or nicked blades to prvent injury. You can clean the excess hair from your blades by usinga small brush or worn out tooth brush. To clean the blades we suggest to immerse the blade only inot a shallow pan of Andis trimmer oil, while the trimmer is running. Any excess hair and dirt that has been accumulated between the blades should come out. After cleaning, turn your trimmer off anddry blades with a dry cloth and start clipping again.