Order online or over the phone

call us at 1-888-520-6689 weekdays

8:30am - 5:00pm central time zone

TOLL FREE1-888-520-6689

Andis T-EDJER Lightweight Trimmer - Model 15430

$ 48.00

Andis T-EDJER Lightweight Trimmer - Model 15430

$ 48.00

Andis® "T-Edjer Lightweight Trimmer"

Model Number: #15430

Powerful & Lightweight Magnetic Motor Trimmer

Fine cutting teeth for trimming necks, beards, mustaches, outlining and edging around the ears. Powerful magnetic motor runs cool quiet. Heavy-duty 8-foot cord with hanger loop.

. Powerful magnetic mortor runs cool and quiet.

. Ideal for fast touch-ups and hair designing.

. Equipped with close-cutting T-blade.

. Lightweight trimmer fits any hand comfortably.

. Fine cutting teeth for trimming necks, beards, mustaches, outlining and edging around ears.

. Heavy-duty 8-foot cord with hanger loop.

Careful workmanship and quality design have been the hallmarks of Andis products since 1922.

Keywords: andis t-edjer lightweight trimmer

Please read the following instructions before using your new Andis timmer. Give it the care that a fine precision built instrument deserves and it will give you years of service. Before starting trimmer remove blade guard (some models may not have a blade guard). Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start trimmer move switch button to ON position, to stop, move switch button back to original position. After using your Andis trimmer, rewrap cord and store in a safe place.


The internal mechanism of your trimmer has been permanently lubricated at the factory. other than the recommended maintenance described in this manual, no other maintenance should be performed, except by Andis company or an Andis authorized service station.


Blades shoudl be oiled before, during, and after each use. If your trimmer blades leave streaks or slows down, it's a sure sign blades need oil. The trimmer should be held in a position shown (Diagram D) to prevent oil from getting into motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter blades (Diagram E). Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are anexcellent trimmer coolant. Always replace broken or nicked blades to prevent injury. You can clean the excess hair from your blades by using a small brush or worn out tooth brush. To blean the blades we suggest to immerse the blades only into a shallow pan of Andis clipper oil, while the trimmer is running. Any excess hair and dirt that has accumulated between the blades should come out. After cleaning, turning your trimmer off and dry blades with a dry cloth and start clipping again.


Your Andis trimmer has been adjusted to line voltage at the factory. However, because of voltage variations it may be necessary to adjust the power setting for your area. If the power adjustment is off, you will usually notice a "clatter", when the trimmer is "on" or introduced into the hair. (It is normal for your trimmer to "clatter" for an instant when initially turned on).


1. Oil the blades.

2. The power screw is located in the lowe rpart of the housing opposite the switch.

3. Turn your trimmer "on"

4. Using a standard screw is driver that fits the clot, turn the powescrew counter clockwise until the trimmer clatters continuously. Then turn the screw clockwise carefully until the clatter ceases.

5. Your trimmer is now adjusted.