Order online or over the phone

call us at 1-888-520-6689 weekdays

8:30am - 5:00pm central time zone

TOLL FREE1-888-520-6689

Clip & Groom Flip Top clipper REPLACEMENT Blade - htc7003rb

$ 21.28

Clip & Groom Flip Top clipper REPLACEMENT Blade - htc7003rb

$ 21.28


Clip & Groom by Hot Tools Flip Top Clipper HTc 7003

FlipTop Cord/ Cordless Clipper
and T- Trimmer HTC7003

  • High-carbon steel blades

    1 Disconnect the FlipTop from its cord
    2 Place it on a flat surface with the blade side up.
    3 Peel back the balck adhesive label in the center of the blade assembly. if necessary, use the blade of a flat head screwdriver or knife to lift the label edge.
    4 Remove the svrew in the center of the blade assembly
    5 Push the blade release buttons. The blade assembly will pop up
    6 Pull the blade assembly off the center post. A small washer and the tension spring may come loose during this process. Make sure they are not misplacedas they will be needed to reassemble the FlipTop.
    7 If the spring came loose, replace the spring onto the center post. Place the replacement blade assembly onto the center post and push down on it until it locks in place. The post on the copper colored drive post ( located underneath the blade) should nestle into the slot on the underside of the blade assembly's white nylon drive plate. If necessary, use your fingers to position the drive wheel so that the post nestles correctly into place.
    8 If the small washer came off, place the small washer over the screws post, insert the screw into the hole in the center of the blade assembly and tighten it.
    9 Replace the black adhesive label back onto the center of the blade assembly.
    UPC: 078729170038